ToolCrib.com

ReviewIf you're just getting started in turning, welcome to a fantastic hobby - and you're looking at the right lathe. This Turncrafter is perfect for beginners, because it's not a big investment, yet it's surprisingly good quality for the price.

On a lathe this size, you'll most likely be making pens, ornaments, candlesticks, small bowls and cups, so the 1/4-horsepower motor is plenty of power. We were frankly impressed that a lathe at this price would have variable speeds, and the speed range is an impressive 750 to 3,200 rpm. You'll use the slower speeds for roughing your column, and the higher speeds will give you great fine cuts.

At 43 pounds, it's sturdy and heavy enough to dampen any vibration you might feel, but it's also light enough to be completely portable, perfect for the home workshop where several benchtops share the same bench top. Its footprint is minimal, at about 2 feet long and just 5 inches wide.

The largest diameter piece you can turn on this lathe is 7-1/2 inches, and the longest piece you can turn is 12-1/2 inches - the distance between the centers on the headstock and tailstock. That leaves open a wide array of projects, limited only by the imagination.

We were impressed, also, that this little machine comes with two tool rests: one is 4-1/2 inches, the other, 7 inches, along with a faceplate (used for turning plates, cups and bowls), a spur center, live tailstock center (rotates with the stock to reduce friction and, thus, heat), a knockout bar and wrench.

Quality, flexibility and price make this lathe a front-running choice for those getting into woodturning as well as for experienced turners who want a separate lathe for small projects such as pens and chess pieces. This is a good buy.--Kris Jensen-Van Heste